Troubleshooting - Amibot Swift Manual Del Usuario

TROUBLE SHOOTING
TROUBLE SHOOTING
Problem
Red LED stays after
1
power on
Vacuum on but can
2
not
collect dirt and hair
3 The product is
moving
backwards after
being started
LED indicators flash
4
in blue after 4hrs
charging
The side brushes
5
crooked, not good to
sweep
The product cannot
6
start
The product circles
7
around only, cannot
go straight
*If all solutions given above don't work for you, please take actions below:
1) Re-set the robot by switching on the power button;
2) If re-set action doesn't work, please send the robot to seller for repairing.
Note: Particular specifications are subjected to change without prior notice.
11
Possible Cause
1. Battery Low condition
2. Main body is picked up
1. The dust bin is full
2. The filter is not installed
correctly
1. The product is on dark
color floor
2. Anti-drop sensor light
was covered
Power supply might been
cut off during charging
Being used for a long time
1. Battery is not installed
properly
2. Battery low
3. The robot is under
protection status
One of the wires of the
wheels might be loosened
Solution
1. Recharge the battery
2. Re-place the robot on
the floor
1. Clean the dust bin
2. Re-install the filter
correctly
1. Put the robot on light
color floor.
2. Clean anti-drop sensor
light.
The robot can be operated
if the battery has been fully
charged for 4hrs
If it becomes crooked,
please scald it in hot water
to recover it to its original
shape
1. To install the battery
correctly
2. To have the battery fully
charged (turn off the
cleaner first)
3. To re-set the robot
1. Open the wheel cover
and connect the loosen
wire properly
2. Send the robot to seller
for repairing