Ec Declaration Of Conformity; Troubleshooting - Fimap FV13.1 + HEPA Manual De Uso Y Mantenimiento

VACUUM CLEANER mod.
comply with the requirements of the following Directives:
• 2014/30/EC EMC
• 2006/42/EC MD
• 2011/65/UE RoHS
• 2009/125/EC Ecodesign
• 2013/666/EU Ecodesign for vacuum
The person authorized to compile the technical file:
Mr. Giancarlo Ruffo
Via Invalidi del Lavoro, 1
37059 S. Maria di Zevio - Verona - Italy 04/09/2021
This chapter lists the most common problems linked with the use of the appliance. If you are unable to resolve the problems with the
information given here, please contact your nearest assistance centre.
PROBLEM
THE APPLIANCE DOES NOT
SWITCH ON
TOO LITTLE SUCTION
- EXCESSIVE DUST
PRODUCTION

EC DECLARATION OF CONFORMITY

The undersigned manufacturer:
FIMAP S.p.A
Via Invalidi del Lavoro, 1
37059 S. Maria di Zevio - Verona - Italy
Tel. +39 045 6060411
Fax +39 045 6060417
E-mail: fimap@fimap.com
declares under its sole responsibility that the products
FV13.1 + HEPA

TROUBLESHOOTING

POSSIBLE CAUSE
The main switch is not activated.
The plug on the appliance's power cable
has not been correctly inserted into the
mains socket.
The electrical specifications of the appliance
do not match the electrical specifications of
the power supply network.
The power cable is damaged.
The vacuum hose is not connected correctly
to the nozzle on the collection tank.
The vacuum hose is not connected
correctly to the extension hose.
The extension hose is not connected
correctly to the vacuum accessory being
used.
The vacuum circuit is blocked (vacuum
hose; extension hose; vacuum accessory).
There is a blockage in the vacuum filters.
www.fimap.com
Press the main switch.
Connect the plug on the appliance's power
cable to the mains socket.
Check that the technical data on the
appliance's serial number plate match the
data of the mains supply.
Contact
immediately.
Connect the vacuum hose correctly to the
nozzle on the collection tank.
Connect the vacuum hose correctly to the
extension hose.
Connect the extension tube correctly to the
vacuum accessory being used.
Remove the obstruction in the vacuum
circuit.
Clear the obstruction in the vacuum filters.
27
FIMAP S.p.a
Legal Representative
Giancarlo Ruffo
SOLUTION
a specialised technician