Switching Off; Cleaning And Maintenance; Storage; Important - Beurer FWM 45 Manual De Instrucciones

Ocultar thumbs Ver también para FWM 45:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23

4.4 Switching off

To switch the foot warmer off, set the sliding switch for massage and heat settings to the setting "0" (OFF).
NOTE
If the foot warmer is not in use, set the sliding switch to "0" (OFF). Disconnect the mains adapter from
the foot warmer. Remove the mains adapter from the socket.

5. Cleaning and maintenance

WARNING
Before cleaning, always remove the mains adapter from the socket first.
Then disconnect the mains adapter cable from the foot warmer control.
Otherwise, there is a risk of damage.

IMPORTANT

The control must never come into contact with water or other liquids, as this may cause damage
To clean the control, use a dry, lint-free cloth. Do not use any chemical or abrasive cleaning agents.
Small marks on the foot warmer can be removed with a damp cloth and, if necessary, with a little liquid
detergent for delicate laundry.
IMPORTANT
Please note that the foot warmer must not be washed, chemically cleaned, wrung out, tumble dried,
put through a mangle or ironed. Failure to observe this may result in damage to the foot warmer.
The removable fleece lining can be washed by hand.
Use a delicate laundry detergent and measure it out according to the manufacturer's instructions.
WARNING
Only use the foot warmer again once the foot warmer and fleece insert have fully dried. Otherwise,
there is a risk of damage.

6. Storage

If you do not plan to use the foot warmer for a long period of time, we recommend that you store it in the
original packaging.
IMPORTANT
• Allow the foot warmer to cool down before storing. Failure to observe
this may result in damage to the foot warmer.
• To avoid damaging the foot warmer, do not place any objects on top
of it whilst storing.

7. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
useful life. Dispose of the unit at a suitable local collection or recycling point. Dispose of the device
in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have
any questions, please contact the local authorities responsible for waste disposal.
14

Publicidad

Tabla de contenido
loading

Tabla de contenido