SMA PPM-RC-10 Instrucciones De Funcionamiento página 9

SMA Solar Technology AG
Damage to the product due to sand, dust and moisture ingress
Sand, dust and moisture penetration can damage the product and impair its functionality.
• Only open the product if the humidity is within the thresholds and the environment is free of sand and dust.
• The product must not be opened in case of splashing water (e.g. from an irrigation system).
• Do not open the product during a dust storm or precipitation.
• Close the product in case of interruption of work or after finishing work.
• Only operate the product when it is closed.
• Store the closed product in a dry and covered location. Observe storage conditions.
• Only use the supplied cable glands when inserting cables.
• The temperature at the storage location must be in the specified range.
Damage to electronic components due to electrostatic discharge
Electrostatic discharge can damage or destroy electronic components.
• Observe the ESD safety regulations when working on the product.
• Wear suitable personal protective equipment for all work on the product.
• Discharge electrostatic charge by touching grounded elements. Only then is it safe to touch electronic
components.
Product can cause radio interference in living areas
The product is a device of ITE class A (EN 55022) and can cause radio interference in living areas.
• Take suitable measures for shielding radio waves when the Cluster Controller is used in the vicinity of living
areas.
Damage to the product due to cleaning agents
The use of cleaning agents may cause damage to the product and its components.
• Clean the product and all its components only with a cloth moistened with clear water.
Electrical installations (for North America)
All installations must conform with the laws, regulations, codes and standards applicable in the jurisdiction of
installation (e.g. National Electrical Code
• Before connecting the product to the utility grid, contact your local grid operator. The electrical connection of
the product must be carried out by qualified persons only.
• Ensure that the cables or conductors used for electrical connection are not damaged.
Operating manual
NOTICE
NOTICE
NOTICE
NOTICE
®
ANSI/NFPA 70 or Canadian Electrical Code
2 Safety
®
CSA-C22.1.).
PPM-RC-10-BE-xx-10 9