Quick Setup - SOUNDMASTER FUR100 Manual Del Usuario

TO USE BACKUP BATTERY
Your clock radio requires one CR2032 lithium battery (not included) to provide
backup power to the clock in the event of a temporary interruption.
1. Place your unit face down on a flat and soft surface.
2. Use a screw driver to open the backup battery compartment door on the back
side of the unit.
3. Slide and remove the battery cover at the bottom of your unit.
4. Insert a new CR2032 lithium battery into the battery compartment with the "+"
side facing up as indicated.
5. Close the battery compartment door and tighten the battery door screw.
When the power supply is interrupted, the clock radio will be powered by the
backup battery. The LED display is turned off, the alarm and the radio do not
function.
CAUTION
Danger of explosion if the battery is incorrectly insert. Replace only with the same or
equivanlent type.
1. INSTALL YOUR OUTDOOR TRANSMITTER
Keep your clock radio and wireless sensor next to each other. Slide back the battery cover
at the back of your wireless outdoor transmitter. Make sure that the channel selector is set
at position 1 (right position). Then insert 2x AAA batteries (not included) into the
compartment. Install the batteries correctly by following the polarity (+ and -) indications in
the battery compartment. Make sure that the switch is in position "1". Replace the battery
door. Mount the Sensor weatherproof and do not expose it to direct sunlight.
2. POWER UP YOUR UNIT
Use only the supplied power adapter!
Insert the DC jack to the back case of your clock radio. Then insert the AC/DC power
adaptor into a standard AC wall outlet.
Your clock radio will receive data signal from the outdoor transmitter in few seconds. Then place
your sensor in a dry and shaded area outdoor away from direct sun and rain. The temperature
readings will become stable and more accurate after the unit is powered up for around 30
minutes.
3. SET THE FM ANTENNA
Extend the FM antenna fully and vary the direction for the best FM reception. Do not strip,
alter or attach to other antennas.
4. RECEIVE RADIO CONTROLLED TIME
In around 3 minutes the clock radio will start to search for the DCF time signal. During the
DCF reception, the LED display becomes dim and all buttons do not function. This normally
takes around 7-10 minutes to complete the reception.
5. MANUALLY SET YOUR WEATHER ICONS
The weather stations computes weather forecast based on changes in air pressure.
However, when using the weather station for the first time, it may take up to a few days of
collecting sufficient information for more accurate forecasts. Manual setting of the weather
forecast can slightly accelerate this process.
Please go to step 6 of "TO SET TIME, 12/24HR, CALENDAR, SNOOZE DURATION,
WEATHER ICON".

QUICK SETUP

2
FUR100 / English Instruction Manual