Storage; Replacement Parts/Accessories; Disposal And Protection Of The Environment - Grizzly ERT 450/8 Traducción Del Manual De Instrucciones Origina

Exchanging the line spool:
1. Disconnect the plug from the
mains socket.
2. Turn over the trimmer so that the
cutting head (11) is facing up-
wards.
3. Simultaneously press the two
locks on the cutting head (11)
and remove the hood (18).
4. Remove the line spool (19) from
the cutting head.
5. Insert the new spool with the
smooth side facing upwards in
the cutting head and thread the
two lines through the line eyelets
(20). Ensure that the line ends
do not slip out of the spool slots.
6. Return the hood.(17) Ensure that
the locks of the hood are accu-
rately inserted in the correspond-
ing recesses of the cutting head.
They lock in audibly.
7. Press the retaining head (17),
release it again and pull the ends
of the cord out a little. Repeat this
process until the ends of the cord
project a little beyond the cord cut-
ter).
Check the string cutter. Do not use
the appliance without a string or
with a defective string. Contact our
nearest Service Centre in case the
string cutter is damaged.

Storage

• Carefully clean the trimmer and its ac-
cessories after each use (see "Clean-
ing and maintenance"), thereby avoid-
ing mould formation.
• Store the trimmer in a dry place well
out of reach of children.
• Do not expose the trimmer for extend-
ed periods to direct sunlight.
• Do not wrap plastic sacks around the
trimmer as this could result in the for-
mation of moisture and mould.
• Do not stand the trimmer on its pro-
tective cover. Suspend it by its upper
handle in such a manner that the
protective cover does not come into
contact with other objects. This is be-
cause the protective cover could be-
come deformed, thereby changing its
dimensions and its safety properties.
Replacement parts/
Accessories
Spare parts and accessories
can be obtained at
www.grizzly-service.eu
If you do not have internet access, please
contact the Service Centre (see "Grizzly
Sercice-Center").
Or obtain a 1.4 mm nylon string from a
specialised dealer and wind it onto the
spool yourself. If you do, mind to use no
more than 2 x 5 m of string and to wind it
strictly parallel along the two thread chan-
nels and against the direction of motor ro-
tation. The arrow on the protective cover
indicates the direction of motor rotation.
Disposal and protection
of the environment
Dispose of the trimmer, its accessories
and the packaging in an environment-
friendly manner.
Electrical appliances must not be
disposed of with the domestic waste
UK
121