Trimmer Settings; Lengthening The Cutting Lines - Grizzly ERT 450/8 Traducción Del Manual De Instrucciones Origina

Caution: Always remove grass
residue from the line cutter so that
the cutting effect is not impaired.

Trimmer settings

Adjusting the additional handle:
The additional handle can be set in dif-
ferent positions. Set the handle in such a
manner that the cutting head is slightly tilt-
ing forwards when in the working position.

Release the knurled nut (16) and
adjust the additional handle (5) in
the required position. Retighten the
knurled nut.
Adjusting the height:
The telescopic tube enables you to adjust
the trimmer to your height.
‚
Release the screw sleeve (7). Adjust
the telescopic tube (8) to the required
length and retighten the screw sleeve.
To adjust the handle rod:
The handle rod turns by 90° and 180°.
ƒ
Pull down the lever (6) and turn the
handle rod (1) until it snaps into the
desired position.
Adjusting the spacing bow
(flower protection):
The spacing bow keeps plants and stalks
that are not to be cut away from the cut-
ting lines.
„
Flap down the spacer bow (13) for
trimming.
If the spacing bow is no longer re-
quired, it can be pushed away back-
wards (park position).

Lengthening the cutting lines

A short or worn string will make
bad cuts. If you notice reduced
cutting performance, you should
therefore check if there is still
enough string on the spool. Pull
the power plug first! Spool replace-
ment is detailed in section „Replac-
ing the Trimming Assembly".
Fully automatic dual line system
The equipment features a fully automatic
dual line system.
The lines will automatically elongate every
time you turn on the appliance. To support
proper line elongation, ensure that the coil
has stopped moving completely before
turning on the appliance again.
If the lines should be longer that defined
by the cutting circle then they will be au-
tomatically cut to the correct length by the
line cutter
Regularly check the nylon lines for
damage and whether the lines still
have the correct length defined by
the line cutter
When no line ends are visible:
• Renew the line spool (see "Cleaning
and maintenance").
Adjusting the line length manually:
• Disconnect the plug from the mains
socket!
Press the retaining head (
lease it again and pull the ends of the
cord out.
UK
17) re-
119