Assembling Instructions; Operation; Switching On And Off - Grizzly ERT 450/8 Traducción Del Manual De Instrucciones Origina

UK
• Use the envisaged cable suspensions
when attaching an extension cable.
• Never carry the equipment by its power
cable. Never pull the cable to discon-
nect the plug from the mains socket.
Protect the cable from heat, oil and
sharp edges. The mains power cable
could be damaged.

Assembling instructions

Always disconnect the plug before
working on the trimmer and wait un-
til the cutting lines have completely
stopped. There is the danger of
electric shock and the possibility of
injury by the cutting lines.
1. Carefully unpack the trimmer
and check that it is complete:
Assembling the protection
cover:
2. Flap the protective cover (10)
open.
3. Place the protective cover (10)
in the guide and turn it anti-
clockwise by 90° up to the stop
( mark).
ê
4. Use the screw from the package
to secure the cover.
Mounting the additional handle:
5. Plug the two black handle rod
discs (14) into the rod openings
(15).
6. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle rod
discs.
7. Screw down the auxiliary
118

Operation

Never use the trimmer without its
protective cover. Always check
the operability of the trimmer
before it is used. Check that the
mains voltage is the same as
indicated on the rating plate. Al-
ways wear goggles when work-
ing with the trimmer.
Please observe local regulations
concerning noise protection.

Switching ON and OFF

1. Form a loop in the end of the ex-
2. Connect the trimmer to the
3. Ensure a safe stance and hold
4. To switch on depress the ON
After the trimmer has been
switched off the cutting head will
continue to rotate for a few sec-
onds. Keep hands and feet well
away.
The ON / OFF switch must not
be locked in place. The trimmer
must not be used if the switch is
damaged. There is the immedi-
handle.
ate danger of injury if the motor
does not switch off after the ON /
OFF switch has been released.
tension cable, conduct it through
the opening in the upper handle
and hang it on to the strain relief
(4).
mains socket.
the equipment firmly with both
hands. Do not deposit the cutting
head on the ground.
/ OFF switch (3). Release the
switch to switch off.