Manual Operation - Casada braintronics AURA Manual De Instrucciones

Remote control

4. MANUAL OPERATION

Tap this icon to go to the [Manual] page.
There are 4 programmes for different partial massage areas to choose from.
•
Select the desired programme, then the automatic programme will start.
•
The functions Kneading | Tapping | Shiatsu have two massage techniques.
•
NOTE: Press the Kneading, Tapping, or Shiatsu mode once to enter mode 1. Press again to
switch to mode 2. Press the button the third time to cancel the selection. Only one mas-
sage mode is available for rolling.
28
Remote control
If the manual function is activated, you will be taken to this page:
When the 4D massage mechanism is located in the neck & shoulders / back / midsection, the
•
massage intensity is automatically regulated, allowing a more careful massage pressure to be
achieved.
Kneading strength and tapping speed are adjustable over 5 levels. With the exception of the Full
•
Back position, the intensity at the Neck & Shoulders / Back / Hip positions cannot be adjusted.
The air pressure intensity is adjustable over 5 levels.
Regulation of the massage mechanism:
•
This can be done in the Full Back position including up and down movement and width adjust-
ment of the massage rollers to activate point or partial massage.
Point massage is massage focused on a certain point of the body with kneading, tapping, and
•
shiatsu massage.
Partial massage is massage focused over an 8 cm interval of the body area, including kneading,
•
tapping, shiatsu, and rolling massage.
29