Publicidad
Step 8
Separate the EXTENSION SLIDES (40NC) from the EXTENSION RAILS (40NA) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (40NA) to the UPRIGHTS (C and D). Use four GOLD 5/16" FLAT HEAD SCREWS (3S)
å
through holes #1 and #4.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the PENCIL DRAWER.
å
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
1
Open end
This large
hole must
be here.
www.sauder.com/services
40NC
Push the black lever in and pull the SLIDE from the RAIL.
3S
4
3
2
D
40NA
1
2
3
4
420166
Open end
This large
hole must
be here.
C
Page 13
Publicidad
