Sauder Shoal Creek 420166 Folleto De Instrucciones página 22

Step 17
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten the DOOR (I) to the LEFT END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each
SCREW a few turns before completely tightening any of them.
Fasten a PULL (7K) to the DOOR (I). Use two SILVER 3/4"
å
MACHINE SCREWS (20S).
Insert the DOOR STOP (4I) into the hole in the LEFT UPRIGHT (D).
å
See the next step for DOOR adjustments.
å
7K
20S
SILVER 3/4" MACHINE SCREW
(2 used for the PULL)
Page 22
4I
B
I
D
420166
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
www.sauder.com/services