Publicidad
Step 15
Insert the non-threaded end of the SHORT SUPPORT ROD (28A) through the RIGHT
å
UPRIGHT (C) and into the ANCHOR PLATE (66G).
Thread the TURNBUCKLE (9A) onto the threaded end of the SHORT SUPPORT ROD (28A).
å
Place the SPACERS (22A) under the SUPPORT RODS (23A and 28A) with the RODS
å
resting in the grooves of the SPACERS.
Hand tighten the TURNBUCKLE (9A) until it is snug. The SPACERS will be tightened
å
between the SUPPORT RODS and the TOP. Now, insert your screwdriver through the large
hole in the middle of the TURNBUCKLE and turn the TURNBUCKLE another half turn.
NOTE: Tighten the TURNBUCKLE if the TOP ever begins to sag.
å
66G
28A
28A
Threaded end
Page 20
C
22A
22A
9A
E
23A
420166
www.sauder.com/services
Publicidad
