Technical Data; Safety Instructions - Desoutter CVI2 TOOL ADAPTOR Manual Del Usuario

6159922480_04
Original instructions.
© Copyright 2021, Ets Georges Renault
44818 St Herblain, FR
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is intended to be connected to
CVI3 FUNCTION, CVI3 VISION, TWINCVI3,
CVI3 FUNCTION ESTOP, CVI3 VISION ESTOP,
TWINCVI3 ESTOP, CVI3 ESSENTIAL controllers
to allow managing ERP, ERF and EME tools.
No other user permitted.
For professional use only.
EMC restriction of use: for industrial use only.

TECHNICAL DATA

Storage and use conditions
● Storage temperature: -20 to +70 °C
(-4 to +158 °F).
● Operating temperature: 0 to 45 °C
(32 to 113 °F).
● Storage humidity: 0-95 % RH
(non-condensing).
● Operating humidity: 0-90 % RH
(non-condensing).
● Altitude up to 2000 m (6562 feet).
● Usable in Pollution degree 2 environment.
● Indoor use only.
Power supply
● Voltage: 15V DC.
● Current: 100 mA.
● Power : 1.5 W.
Tool Motor power supply voltage
● 115 V 3~
Weight
● 1.5 kg (3.31 lb.s).

SAFETY INSTRUCTIONS

Class A digital device
This equipment has been tested and found
to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area
is likely to cause harmful interference in which
case the user will be required to correct the
interference at his own expense.
Any changes or modifications to this equipment
not expressly approved by Ets Georges Renault
may cause, harmful interference and void the
FCC authorization to operate this equipment.
CVI2 tool adaptor must be connected
only to a CVI3 Function or a CVI3 Vision
controller.
To connect CVI2 tool adaptor to
TWINCVI3 controller, contact your local
Desoutter representative.
INSTALLATION
Connecting CVI2 tool adaptor to controllers
A
See page 4.
Switch off the controller before
disconnecting:
● The tool.
● The extension cable.
● The tool cable.
● The adaptor from the controller.
Connecting tool cable and extension cable
(optional)
Extension
Tool cable
(Optional)
ERP* range 6159170830
6159170840
6159170850
6159170860
6159170870
ERF* range 6159170830
6159170840
6159170850
6159170860
6159170870
EME* range 6159170830
6159170840
6159170850
6159170860
6159170870
6159170880
6 / 58
English
Tool cable
6159176410
6159176410
6159175410
6159175420
6159175430
10/2021