Indicator Lights; Optional Features - Uline H-3448 Guia De Inicio Rapido

Activation
Figure 7
Sensitivity
Adjustment
Low Product
(Yellow) and
Trouble (Red)
Indicator Light
ADJUSTING THE ACTIVATION SENSITIVITY
To adjust the activation sensitivity set the Activation
Sensitivity Adjustment switch as desired. (See Figure 7
and Adjustment Settings chart)
ADJUSTING THE DELAY BETWEEN DISPENSES
To adjust the length of time between dispenses, set the
Delay Adjustment switch to 0.5, 1 or 1.5 seconds as
desired. (See Figure 7 and Adjustment Settings chart)
PUSHBUTTON LOCK FEATURE
1. To install pushbutton remove decorative hole plug if
one is installed.
2. Remove pushbutton from back of dispenser.
3. Raise end of lock spring. Do not overstress spring.
(See Figure 8A)
4. Slide pushbutton under lock spring. Insert button
through hole in door. (See Figure 8B)
Lock Spring
Pushbutton
PAGE 3 OF 12
OPERATION AND FEATURES CONTINUED
Sheet
Delay Length
Adjustment Adjustment
Low Battery
Indicator
Light

OPTIONAL FEATURES

Figure 8
A
ADJUSTING THE SHEET LENGTH
To adjust the length of sheets that are dispensed, set the
Sheet Length Adjustment switch to short, medium or long
as desired. (See Figure 7 and Adjustment Settings chart)
ADJUSTMENT
SETTINGS
Switch Position
Activation
Sensitivity
Delay
Sheet Length

INDICATOR LIGHTS

1. The Low Battery Indicator Light will begin to blink
yellow and red intermittently when the battery life
is getting low. (See Figure 7) The light will remain on
when the batteries need replacement.
2. The Low Product Indicator Light will blink yellow
when the product roll can be moved to the stub roll
position. (See Figure 7) The indicator light will blink
red twice and then pause when the unit has been
used incorrectly or has malfunctioned or needs to
be checked for a paper jam. Unit may be reset
by opening and closing the housing cover. The
indicator light blinks green for 1/4 second when a
proper towel tear has occurred
(only for the 1st 25 sheets after initial power-up).
DECORATION STRIP INSTALLATION - WINDOWS
1. Open cover and insert decorator strip.
(See Figure 9A)
2. Slide decorator strip into place. (See Figure 9B)
3. Close cover firmly and lock.
B
Top Middle
Low Medium
0.5 seconds 1 second
8 inches 11 inches
A
Bottom
High
1.5 seconds
14 inches
Figure 9
B
0721 IH-3448