For Your Safety - Bosch Xeo Manual Original

OBJ_BUCH-377-007.book Page 20 Tuesday, August 9, 2011 10:13 AM
20 | English
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ESC, D-70745 Leinfelden-Echterdingen
2007
Dr. Egbert Schneider
Senior Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, xx.xx.2011
Assembly

For Your Safety

Warning! Prior to any maintenance and cleaning, switch the machine off
and secure the lock-off button 2.
Battery Charging (see figure A)
Do not use other battery chargers. The supplied battery charger is de-
signed for the Lithium-Ion battery in your machine.
Observe the mains voltage! The voltage of the power supply must corre-
spond with the data given on the nameplate of the battery charger. Battery
chargers marked with 230 V can also be operated with 220 V.
3–5 h
The lithium-ion battery can be charged at any time without reducing its service
life. Interrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic
Cell Protection (ECP)". When the battery is empty, the machine is switched off
by means of a protective circuit: The inserted tool no longer rotates.
Do not continue to press the On/Off switch after the
WARNING
machine has been automatically switched off. The bat-
tery can be damaged.
A battery that is new or has not been used for a longer period does not develop
its full capacity until after approx. 5 charging/discharging cycles.
When the battery charge-control indicator 7 lights up red while the On/Off
switch 1 is pressed, then the battery has less than 30% of its capacity and
should be charged.
– Plug the mains plug of the battery charger into a socket outlet and the charger
plug 10 into the socket 9 on the rear side of the handle.
The battery charge-control indicator 7 indicates the charging progress. The indi-
cator flashes green during the charge procedure. The battery is completely
charged when the indicator lights up green continuously.
1 609 929 W36 | (9.8.11)
Dr. Eckerhard Strötgen
Head of Product
Certification
The battery is supplied partially charged.
To ensure full battery capacity, completely charge
the battery (at least 3–5 hours) before using for
the first time.
The power tool cannot be used during the charge
procedure; it is not defective when inoperative dur-
ing the charging procedure.
Bosch Power Tools