Publicidad
Step 14
Carefully turn your unit over onto its front edges. Lay the
å
BACK (G) over your unit.
Make equal margins along all four edges of the BACK (G).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the holes needed.
Page 18
This hole should be
closer to this edge.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
418238
1N
NAIL
(18 used in this step)
www.sauder.com/services
Publicidad
