Sauder Kendall Square 418238 Manual De Instalación página 23

Step 19
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (J) to the LEFT END (B) as shown in
å
the lower diagram. Use the screws in the HINGES. You
should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (25K) to the DOOR (J). Use a BLACK 7/8"
å
MACHINE SCREW (37S).
Peel a FELT DISC from the FELT DISC CARD (1M) and
å
stick it on the DOOR where it comes in contact with
the UPRIGHT (C).
See the next step for DOOR adjustments.
å
1M
25K
1M
www.sauder.com/services
B
J
37S
BLACK 7/8" MACHINE SCREW
(1 used for the KNOB)
C
418238
Stop
Mounting
screw
Hinge
Page 23