Publicidad
Step 15
1
D20
Groove
Insert the DRAWER SIDES (D20 and D21) at an
å
angle into the slot at each end of the LARGE
DRAWER FRONT (N).
3
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M67) to the LARGE
å
DRAWER FRONT (N). Tighten one HIDDEN CAM.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
N
Maximum
210 degrees
Minimum
190 degrees
M67
N
VIEW THE T-LOCK BOX VIDEO
2
D21
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the LARGE DRAWER BOTTOM (D985) into the
å
grooves in the DRAWER SIDES (D20 and D21) and
LARGE DRAWER FRONT (N).
4
Arrow
D20
Fasten the LARGE DRAWER BACK (D180) to the DRAWER
å
SIDES (D20 and D21) and DRAWER BRACE (M67). Use five
BLACK 1-9/16" FLAT HEAD SCREWS (30S). Repeat this step
for the other drawer using the DRAWER FRONT (O), DRAWER
BACK (D74), and DRAWER BOTTOM (D716).
418238
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D985
D20
N
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(9 used in this step)
D180
M67
D21
D21
30S
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Page 19
Publicidad
