Measurement Operation; Dc/Ac Voltage Measurement; Measuring Resistance - Ega Master EGA Tronik 51247 Manual De Instrucciones

A. DC/AC Voltage Measurement (see figure 3)
Warning!
The DC Voltage ranges are:
400mV, 4V, 40V, 400V and 600V.
The AC Voltage ranges are:
4V, 40V, 400V and 600V.
To measure DC voltage, connect the Meter as follows:
1. Insert the red test lead into the Hz Duty%
COM terminal.
2. Set the rotary switch to
Press SELECT to switch to AC measurement mode or press
measurement mode.
3. Connect the test leads across with the object being measured. The measured value shows on the
display.
Note:
When DC/AC voltage measurement has been completed, disconnect the connection between
the testing leads and the circuit under test and remove testing leads from the input terminals.
B. Measuring Resistance (see figure 4)
Warning!
The resistance ranges are:
400 , 4k , 40k
26

MEASUREMENT OPERATION

To avoid harms to you or damages to the Meter from eletric shock, do not
attempt to measure voltages higher than 600V AC/DC, although readings may
. DC mesaurement mode and auto ranging is a default.
To avoid damages to the Meter or to the devices under test, disconnect
circuit power and discharge all the high-voltage capacitors before measuring
,400k ,4M and 40M
be obtained.
(figure 3)
V
terminal and the black test lead into the
REL
resistance.
.
to switch to manual ranging