Frequency Measurement - Ega Master EGA Tronik 51247 Manual De Instrucciones

E. Frequency Measurement (see figure 7)
attempt to measure voltages higher than 600V AC/DC, although readings may
Warning!
The resistance ranges are:
10Hz, 100Hz, 1kHz, 10kHz, 100kHz, 1MHz and 10MHz.
To measure frequency, connect the Meter as follows:
1. Insert the red test lead into the Hz Duty%
COM terminal.
2. Set the rotary switch to Hz.
3. Connect the test leads across with the object being measured. The measured value shows on the
display.
Note:
When frequency measurement has been completed, disconnect the connection between the
testing leads and the circuit under test, and remove the testing leads away from the input terminals
of the Meter.
To avoid harms to you or damages to the Meter from eletric shock, do not
be obtained.
(figure 7)
V terminal and the black test lead into the
29