Duty Cycle Measurement; Dc/Ac Current Measurement - Ega Master EGA Tronik 51247 Manual De Instrucciones

F. Duty Cycle Measurement (see figure 8)
Warning!
The duty cycle range is: 0.1%~99.9%.
To measure duty cycle, connect the Meter as follows:
1. Insert the red test lead into the Hz Duty%
COM terminal.
2. Set the rotary switch to Hz and press
3. Connect the test leads across with the object being measured. The measured value shows on the
display.
Note:
When duty cycle measurement has been completed, disconnect the connection between the
testing leads and the circuit under test, and remove the testing leads away from the input terminals
of the Meter.
G. DC/AC Current Measurement (see figure 9)
The measuremnet ranges of current are: 40.00 A
30
To avoid harms to you or damages to the Meter from eletric shock, do not
attempt to measure voltages higher than 600V AC/DC, although readings may
REL
be obtained.
(figure 8)
V
terminal and the black test lead into the
to select Duty Cycle measurement mode.
and 400.0 A
(figure 9)
.