Deactivation - MBM AQE477 Instrucciones Para El Funcionamiento

5. 3.
INSTRUCTIONS FOR USE

Deactivation

At the end of the work cycle, turn the knobs on the appliance
to "Zero".
The appliance must be cleaned regularly and
every incrustation or food deposit removed. See
chapter: "Maintenance".
If present, the indicator lights must be off at the
end of the work cycle.
Check the cleanliness and hygiene of the appliance; see
"Maintenance".
Close the network locks upstream the appliance (Gas - Water
- Electric).
Humidity residue deposited on the grill can
damage the appliance and cause the grills to
wear quickly.
In order to eliminate all humidity residue on the
grills thus avoiding quick wear, once routine
cleaning has been finished, turn the appliance on
for approximately 10'.
Wait for the temperature of the grill to cool off so that the
operator is not burnt.
Check to make sure the drain piping has no obstructions
(Fig.3).
Take out the drawers and clean it if necessary (Fig.4 see 4
Maintenance).
While draining burnt oils, the risk of being burnt
remains. This risk can occur by unintentional
contact with oil processed at high temperatures.
Before operating, wait for the burnt oil to cool off.
The burnt oil collection container has a limited
capacity. Keep an eye on the container as it fills
while oil is emptied from the cooking compartment.
Fill the recipient 3/4 to handle it safely.
Once the recipient has reached 3/4 its capacity,
remove it from its seat, empty it and put it back in
place.
Empty the container in compliance with waste
disposal procedures in force in the country where
the appliance is used and reposition the emptied
recipient in its housing.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
3
Fig.
4
Fig.
Fig.
- 12 - - 12 - 12 12
5