Cleaning For Prolonged Deactivation - MBM WGE74 Manual De Uso E Instalación

direct water or steam cleaners jets for
cleaning operations.
1- Lift the cooking grill, and using
a non-abrasive sponge, clean the
entire surface thoroughly with soapy
lukewarm water.
2- Rinse the parts and carefully dry
all the surfaces using non-abrasive
material;
Afterwards dry it thoroughly and put it
back in place.
3- Remove, drain and carefully wash the
drawers, after the cleaning operations
dry it and put it back in its seat.
4- Carefully reposition all of the parts
removed in their housing, making sure
not to invert the assembly sequence.
If necessary, repeat the operations
described above for a new cleaning cycle.
GRILL: For cleaning operation use a
non-abrasive sponge and a neutral
liquid detergent.Clean the grill with a
moist cloth.
Humidity residue deposited on the
grill can damage the appliance and
cause the grills to wear quickly.
In order to eliminate all humidity
residue on the grills thus avoiding
quick wear, once routine cleaning
has been finished, turn the appliance on
for approximately 10'.
CLEANING FOR PROLONGED
DEACTIVATION /
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
To conclude the operations see chap.
5 / Operations for commissioning / Pro-
longed decommissioning
Air out the appliances and rooms
regularly.
SUMMARISED TABLE /
OPERATION - FREQUENCY
Before proceeding with the ope-
rations, see chapter 2 "Duties
and Qualification"
Should a problem occur, the ge-
neric operator performs the first
search and, if qualified, elimina-
tes the cause of the problem and re-
stores the appliance correctly.
If the problem cannot be resol-
ved, turn the appliance off, di-
sconnect it from the electrical
mains and shut all the supply valves.
Then contact authorized customer
service.
The authorized maintenance te-
chnician intervenes when the
generic operator was not able to pin-
point the cause of the problem, or
whenever restoration of correct ope-
ration of the appliance entails execu-
ting operations for which the generic
operator is not qualified.
If the power cable is damaged,
contact the authorised techni-
cal assistance service to have
it replaced.
- 17 -
MAINTENANCE
8.
EN