Enhancing your system
DK-AP2
DK-AP2(BK)
The connection lead is not included. Purchase a commercially
ENGLISH
available lead as shown below.
Portable audio
player
Computer
To the line output socket
Audio cable
(not supplied)
Listening to the playback sounds from portable
audio player, computer, etc.
1
Use an Audio cable to connect the portable audio player,
computer etc. to the AUX IN socket.
When using video equipment, connect the audio output to this
unit and the video output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Play the connected equipment.
If volume level of the connected device is too high, sound
distortion may occur. Should this happen, lower the volume of
the connected device.
Note:
To prevent noise interference, place the unit away from the
E-11
television.
A
U
X
N I
V
D I
E
O
O
U
T
D
C
N I
V 6
A
U
X
N I
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
Symptom
When a button is
Set the unit to the power stand-by
pressed, the unit does
mode and then turn it back on.
not respond.
No sound is heard.
Is the volume level set to "0"?
Remote control
Symptom
The remote control
Is the AC power lead of the unit
does not operate.
plugged in?
Is the battery polarity correct?
Is the battery dead?
Is the distance or angle incorrect?
Does the remote control sensor
receive strong light?
iPod
Symptom
No sound is produced.
The iPod is not playing.
No image appears on
The iPod is not properly connected
the TV/monitor.
to the unit.
Is the AC power lead of the unit
plugged in?
The video cable is not properly
connected.
The TV/monitor's input selection is
not properly set.
iPod will not charge.
The iPod is not making full contact
with the iPod connector.
The main unit is using batteries as
power supply.
Possible cause
Possible cause
Possible cause