Bimar HFP10 Folleto De Instrucciones página 20

disposed of according to their raw material (see the symbol stamped on each one) and
according to the provisions of their municipality. The bag containing the set with brackets
and fixing screws or the remote control, which is unmarked due to its small size, is made of
polyethylene; therefore you have to follow the procedures for the disposal of this type of
plastic.
• Before connecting the appliance, check that the voltage shown on the data plate matches
that of your electricity, and that the electric plug is grounded. In the event of
incompatibility between the electric outlet and the plug of the heater, have the outlet
replaced with another more suitable type by professionally qualified personnel, who will
make sure that the section of the wires of the outlet is appropriate for the absorbed power
of the heater (10A). In general, the use of adapters or extension cords is not recommended;
if their use is indispensable, they must conform to existing safety standards and their
current capacity (amperes) must not be less that the maximum of the heater.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Position the appliance far from other sources of heat, inflammable materials (curtains,
carpets, etc.), inflammable gases or explosive materials (spray cans) and from materials that
can deform on exposure to heat.
• Do not use this heater in the immediate surroundings of a bath, a shower or a swimming
pool. (to avoid drops of water falling on the heater or the heater falling in the water), or in
places where it could be subject to shocks; the appliance should not be placed under or
near windows.
• The appliance should only be used fastened to a wall with a flat surface free of rough spots,
stable and resistant to heat.
• The installation kit consists of: - no. 1 metal bracket, no. 6 anchors, no. 6 (40x4 mm)
screws, no. 1 flange and no. 2 (10x4 mm) screws. We recommend that you put all the
installation parts in a container in a safe place, to avoid losing parts, but also to make sure
that children do not play with small parts. The electric fireplace should only be mounted
using the mounting kit supplied.
• The wall to which the appliance is fastened must be made of bricks and/or heat-resistant
material (not wood or easily-overheatable synthetic material); first check to see if pipes
(water, gas, etc.) or electrical cables are embedded in the area you will use for mounting the
brackets; also follow these directions for installation (see figure).
• The "minimum" free space to be respected in the installation (referring to the glass): 600
mm from the floor, 1000 mm from the ceiling and 500 mm from the sides.
• Fasten the bracket to the wall horizontally (the projection must be at the top), drill no. 5
holes in the wall (before drilling holes is a good idea to measure the centre-to-centre
distance between the holes), insert the anchors and fasten the bracket with the screws
provided. After fastening, make sure that the bracket is secure enough to support the
weight of the fireplace.
• Fasten the flange to the bottom (Figure 3) of the chimney using the two screws provided.
20/64