Publicidad
Idiomas disponibles
Idiomas disponibles
Temperature adjustment
Note: the ambient temperature is adjustable through the remote control, while it's not
adjustable in the "manual" mode. The default temperature is 20°C.
Note: the heating comes into operation only when the set temperature is higher than the
room temperature.
•
Press the + or – button to set the temperature, which value is included between 15 and 30
°C.
•
Once the temperature setting is finished, the display with the value flashes for about 5
seconds; after that it shows the ambient temperature.
Weekly schedule setting (Timer)
1.
It's possible to schedule up to 10 different time intervals.
2.
Each interval has its own day, switching-on and switching-off time.
3.
The maximum duration of each interval is 23 hours and 50 minutes.
4.
If the switching-off time of the interval falls on the next day, it's not necessary to set the
day, just set the switching-off time.
5.
Press the TIMER SET "3" button, and the interval number will start flashing (01-10).
6.
Press the + or - button to select an interval.
7.
Press the TIMER SET button, and the cursor to the left of the day will start flashing.
Press the o ▲ o ▼ button to move the cursor to the corresponding day. Press the
8.
+ button to add a corresponding day or press the - button to delete a day.
9.
Press the TIMER SET button to set the power on time (ON symbol activated). The time
parameter will start flashing.
10. Press the + or – button to set the time.
11. Press the TIMER SET button and the minute digit will start flashing.
12. Press the + or – button to set the minutes.
13. Press the TIMER SET button to set the switch-off time (OFF symbol lit). The hour digit
will start flashing.
14. Press the + or – button to set the time.
15. Press the TIMER SET button and the minutes digit will start flashing.
16. Press the + or – button to set the minutes.
17. Press the TIMER SET button and the temperature digit will start flashing.
18. Press the + or - button to set the temperature.
19. Press the TIMER SET button to continue with the interval setting or press the OK button
to confirm the setting. To set the programming for the whole week, repeat the previous
steps.
Display of the interval setting
• Press the TIMER SET button.
• Press the + or - button to check the switch-on time of the set intervals one by one.
• To check the switching-off time, press the ▲ button.
• Press the + or - button to check the switching-off time of the set intervals one by one.
23/64
Publicidad
