Important - Worx WG751E Manual De Instrucciones

Power indicator light
See details in BATTERY STATUS
part

IMPORTANT:

When only one light is
illuminated, your battery
is overly discharged, even
though the machine may
still be capable to work.
Continuing to operate your
machine with the battery in
this discharged condition
may reduce the life and
performance of your battery.
When no light is illuminated,
at least one battery is not
fully installed or battery may
be defective, please double
check the batteries are fully
seated into position.
Starting and Stopping
Adjusting the cutting height
WARNING! Stop, release
switch lever and wait until
the motor stops before adjusting
height. The blades continue
to rotate after the machine is
switched off, a rotating blade can
cause injury. Do not touch rotating
blades.
Storage
BATTERY STATUS (See Fig. H)
• Before starting or after use, press the button
beside the power indicator light on the machine to
check the battery capacity.
• During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
• For the machine with 2 battery packs with different
power, the power indicator light displays the
battery condition with the lower one of the two
batteries.
Battery
indicator light
status
Five green lights
The two batteries are in a
( ) are
highly charged condition.
illuminated.
The two batteries have a
Two, three or four
remaining charge. The more
green lights are
lights are illuminated, the
illuminated.
more battery capacity.
Cordless Lawn mower
See Fig. H
See Fig. I1, I2, I3
See Fig. J
See Fig. K1, K2
Battery condition
The battery level of at least
Only one green
one battery pack is very low.
light ( ) is
Please check and charge the
illuminated.
battery pack.
At least one battery is not fully
No light is
installed or battery may be
illuminated.
defective.
At least one battery is over
discharged (please refer to
Only one light is
the battery charge condition),
flashing twice per
please recharge the two bat-
cycle.
teries at once before use again
or storage.
Only one light At least one battery is hot,
is flashing three wait for them cool down
times per cycle. before start again.
Only one light is The machine is over load.
flashing four times Raise the cutting height or
per cycle. push slowly.
MULCHING MOWING TIPS
While mulching, your new mower is designed to cut
the grass clippings into small pieces and distribute
them back into the lawn. Under normal conditions,
the mulched grass will biodegrade quickly and
deliver nutrients to the lawn. Please review the
following recommendations for optimum mulching
performance.
1) Avoid mowing when the grass is wet from rain or
dew. Wet grass may form clumps which interfere
with the mulching action and reduce the runtime.
The best time to mow the grass is in the late
afternoon when the grass is dry and the newly cut
area will not be exposed to direct sunlight.
2) For the best mulching performance, set the cutting
height to remove about one third of the grass
blade length, ideally no more than 40mm at one
time. If the lawn is overgrown, it may be necessary
to increase the cutting height to reduce the
pushing effort and prevent overloading the motor.
For extremely heavy mulching, it is advisable to
first cut at a high cut height setting, and then re-cut
to the final cut height. Otherwise, make narrower
cuts and mow slowly.
3) For the best performance, keep the mower
housing free of built-up grass. From time to time
turn off mower and wait for the blades to come to
a complete stop. Then unplug the safety key and
turn mower on its side. Using an object such as a
stick, wipe out any accumulation of grass around
the blade area. Be careful of the sharp edges of the
blade. Ensure to clean the blade area often when
cutting wet or new grass and every time after the
machine is used.
4) Certain types of grass or grass conditions may
require that an area be mulched a second time
15
EN