Worx WG751E Manual De Instrucciones página 17

TROUBLESHOOTING
PROBLEM
1. Mower doesn't run
when switch lever is
activated.
2. Motor stops while
mowing.
3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
4. Mower is too hard
to push.
5. Mower is abnormally
noisy and vibrates.
6. Battery charger LED's
not on.
7. Battery charger LED
does not flip to green.
8. Mower not picking
up clippings with the
Grass Collection Bag.
9. When mulching there
are clippings visible.
10. Low or diminished
run-time after many
uses
11. The battery charger
LED flashes red and
the battery can't be
charged.
Cordless Lawn mower
SOLUTION
A. Check to make sure safety key has been installed and is fully seated and that
button on switch housing is being completely pushed.
B. Release switch lever to turn mower off. Remove safety key, turn mower over
and check that blade is free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
A. Release switch lever to turn mower off. Remove safety key, turn mower over
and check that blade is free to turn. If not free, return to an authorized servicer.
Blade should turn freely.
B. Raise cutting height of wheels to highest position and start mower.
C. Has battery been fully charged? Plug in charger and wait for green light to
come on.
D. Avoid overloading the mower. Slow down the cutting pace by pushing mower
slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait for green light to come on. "
B. Release switch lever to turn mower off. Remove safety key. Turn mower over and
check: Blade for sharpness - Keep blade sharp. Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each wheel for free
rotation.
A. Release switch lever to turn mower off. Remove safety key. Turn mower on side
and check blade to ensure it has not been bent or damaged. If blade is damaged,
replace with a replacement blade. If the underside of the deck is damaged return
mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still vibrates: Release
switch lever to turn mower off, remove safety key and remove blade. Rotate
blade 180 degrees and retighten. If mower still vibrates, return the mower to an
authorized service center.
A. Check plug connection.
B. Replace charger.
A. Battery needs to be diagnosed. Take to authorized service center.
A. Remove mulch plate when bagging.
B. Chute clogged. Release switch lever to turn mower off. Remove safety key.
Clear chute of grass clippings.
C. Too much cut grass. Raise cutting height of wheels to shorten length of the cut.
D. Bag full. Empty bag more often.
A. Too much cut grass. Raise cutting height of wheels to shorten length of the cut.
Do not cut off more than 1/3 of total length.
B. Check blade for sharpness. Always keep blade sharp.
A. Return to Authorized Service location - may need new battery.
A. The battery overheats after continuous use. Remove battery from the charger
and allow it to cool to 42°C or less.
17
EN