Cequent Performance Products 76034 Instrucciones De Instalación página 5

5. Feed pull wire though hole in bracket on passenger side. Raise hitch into position, over exhaust and
align with existing weldnuts in frame rail and ½-13 carriage bolt installed in Step 4. Install M12 hex bolts
and conical washer as shown.
7. Tighten all M12 CL.8.8 fasteners with torque wrench to 68 Lb.-Ft (92 N*M) , Tighten all
½-13 GR5 fasteners with torque wrench to75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
6. Remove pullwire and install conical washer
and hex nut on carriage bolt.
8. Raise exhaust back into position (3 places). Note: Spraying
a lubricant or soapy water on the metal hanger rod and the
rubber isolator helps
Sheet 5 of 15 76034NP 4-29-16 Rev. A