Blade FR-TEC SUZUKA WHEEL ELITE NEXT Manual Del Usuario página 12

Connection and installation with Nintendo Switch™
To use the Suzuka Wheel Elite Next on Nintendo Switch™ follow the steps in the order listed below:
1. Insert the pedal cable into the "Pedal port" on the steering wheel.
2. Insert the shifter cable into the "Shifter port".
3. Connect the USB cable from the steering wheel to the USB port on the Nintendo Switch™ game console.
4. Turn on the Nintendo Switch™ console.
5. When the installation is complete, the red LED on the steering wheel will light up.
6. To take a screenshot, simultaneously press the "SHARE" button and the "OPTIONS" button.
The connection and installation with Nintendo Switch™ have the following operating mode:
a. Gamepad Mode: activated when connected with the pedals and with the shifter disconnected. In Gamepad mode,
the steering wheel works like the directional buttons, the steering is not progressive. (The "Need for Speed" series only
supports this mode.)
Connection and installation with PC
To use the Suzuka Wheel Elite Next on a PC follow the steps in the order listed below:
1. Insert the pedal cable into the "Pedal port" on the steering wheel.
2. Insert the shifter cable into the "Shifter port".
3. Insert the USB cable into the USB port on the PC.
4. When the installation is complete, the red LED on the steering wheel will light up.
The connection and installation with a PC have two operating modes:
a. Steering Wheel Mode: activated when connected with the pedals and with the shifter disconnected. In Gamepad mode,
the steering wheel works like the directional buttons, the steering is not progressive.
b. Gamepad Mode: activated when connected with the pedals and the shifter. In Steering Wheel mode, the steering angle
sensitivity is enabled, and the steering is progressive and identical to the steering of a real steering wheel.
Connection mode:
a. PC (Xinput):
1. The preset connection mode is Xinput.
2. Press and hold the "HOME" button for 3 seconds to enter the Dinput connection mode. The red LED will blink for 3
seconds.
3. Press and hold the "HOME" button for 3 seconds to return to Xinput connection mode.
b. PC (Xinput):
1. Open the drivers.
2. Press "SETUP".
3. Install the drivers following the instructions.
4. Connect the steering wheel to the PC.
5. Go to Start.
6. Go to Control Panel.
7. Go to Devices and Printers.
8. Right click on Devices.
9. Go to Controller Settings.
10. Go to Properties.
12