Blade FR-TEC SUZUKA WHEEL ELITE NEXT Manual Del Usuario página 9

a. Low sensitivity level:
1. Press the "PROG" button once, the red LED will blink rapidly.
2. Press the up button on the "DIRECTIONAL PAD" to set the steering wheel sensitivity to low.
3. The sensitivity is set when the red LED stays steadily on.
b. Medium sensitivity level:
1. Press the "PROG" button once, the red LED will blink rapidly.
2. Press the right or left button on the "DIRECTIONAL PAD" to set the steering wheel sensitivity to medium.
3. The sensitivity is set when the red LED stays steadily on.
d. High sensitivity level (preset):
1. Press the "PROG" button once, the red LED will blink rapidly.
2. Press the down button on the "DIRECTIONAL PAD" to set the steering wheel sensitivity to high.
3. The sensitivity is set when the red LED stays steadily on.
Set the steering angle to 900°
1. Position the "Rotation selector" at 900º.
2. Press the "PROG" button once. The red LED will blink rapidly.
3. Rotate the steering wheel from the neutral position to the right or to the left always exceeding 60° of rotation and hold
in this position.
4. Press and hold the "OPTIONS" button for 7 seconds until the red LED is steadily on.
5. The rotation angle is now set to 900º.
Reset the steering angle to 270°
1. Position the "Rotation selector" at 270º.
2. Press the "PROG" button once. The red LED will blink rapidly.
3. Press and hold the "OPTIONS" button for 7 seconds until the red LED is steadily on.
4. The rotation angle is now set to 270º.
Features of the pedal base
The pedal base is made up of 3 pedals:
•
Left pedal (clutch).
• Mid pedal (brake).
•
Right pedal (accelerator).
Introducing the 6-speed shifter
NOTE: If the game does not support the use of the manual shifter, then it cannot be used.
Gear shift function:
• The gear shift has two operating modes depending on the position of the "Gear shift mode" switch:
a. With the "Gear Shift Mode" switch set to 0/off. In this mode, the shifter positions are 1st, 2nd, 3rd, 4th, 5th, 6th, and
reverse.
b. With the "Gear Shift Mode" switch set to I/on. In this mode, the shifter positions are 7th, 8th, 9th, 10th, 11th, 12th, and
reverse. This mode only works for PC use.
9