Blade FR-TEC SUZUKA WHEEL ELITE NEXT Manual Del Usuario página 13

Steering wheel test:
• In the test interface, you can test the operation of the buttons and the steering wheel rotation separately.
• You can calibrate the steering wheel rotation in the calibration interface.
• ou can test the vibration in the vibration interface.
• You can test the operation of pedals and gears in the test interface.
Delete drivers:
1. Go to Start => Go to Control Panel => Go to Programs and Features.
2. Find the name of the driver and click on "delete".
Download the drivers at: https://blade.es/en/producto/suzuka-wheel-elite-next-2/
Unload Drive:
• Startup/Control Panel /App & Function.
• Find the drive name to be deleted in the "Unload or Change App"menu. Click "Delete" and operate according to
the prompt for unload.
TROUBLESHOOTING
• If after the installation setup the red LED does not light up, reconnect the steering wheel and repeat the installation setup.
• When the steering wheel does not respond, please disconnect the steering wheel and reconnect it, performing the installation
steps again in the given order.
• The main controller must be switched off during the installation process in order to avoid a connection failure during insta-
llation.
• Since the steering wheel has a button mapping memory, if the buttons are incorrectly configured, follow the steps in "RESET
BUTTON MAPPING" or "FACTORY RESET" to clear the memorised settings.
• If any pedal or direction is not set in the correct place, follow the steps to correct the settings:
1. Position the "Rotation selector" at 270º
2. Press the following buttons "L1 + L2 + R1 + R2" at the same time. The red LED light on the steering wheel will blink at a
frequency of once per second.
3. Rotate the steering wheel slowly and fully to the left. The red LED light on the steering wheel will blink at a frequency of
twice per second.
4. Rotate the steering wheel slowly and fully to the right. The red LED light on the steering wheel will blink at a frequency of
three times per second.
5. Press the right pedal to its maximum position. The red LED light on the steering wheel will blink at a frequency of four
times per second.
6. Press the mid pedal to its maximum position. The red LED light on the steering wheel will blink at a frequency of five
times per second.
7. Press the left pedal to its maximum position. The red LED light on the steering wheel will blink slowly.
8. Press the "OPTIONS" button, the correction is now complete.
13