EGO ST1510E Manual De Instrucciones página 13

WARNING:
To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
MOUNTING THE GUARD
WARNING:
Always wear gloves when mounting or
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING:
Never operate the tool without the
guard firmly in place. The guard must always be on the
tool to protect the user! When the guard is fixed, never
attempt to remove or adjust the guard, if a replacement
is needed, it should be performed by a qualified service
technician!
Align the two bolts, which are pre-assembled on the guard,
with the two screw holes in the shaft (Fig. B), and then
tighten them with the supplied hex wrench(Fig. C).
Make sure the guard is fixed according to Fig. B & C, any
reverse fixing will cause great danger!
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
Push the front-assist handle onto the shaft (Fig. E), then
insert the clamping block into the handle slot (Fig. F), mount
the locking pole, and clamp them with the wing nut
(Fig. G). The sequence is as Fig. D shown. Lastly, adjust
the front-assist handle between the soft sleeve and the
label to make sure your front arm is straight when using
the trimmer (Fig. H) and then lock the lever of the locking
pole (Fig. I).
Fig. D & H parts description see below:
D-1 Front-assist Handle
D-2 Locking pole
D-3 Clamping Block
NOTICE:
The front-assist handle should be turned
upwards to point toward the top of the rear handle.
WARNING:
Only fix the front-assist handle between
the soft sleeve and the label on the shaft.
WARNING:
The tool can not be used without the
front-assist handle securely fixed.
MOUNTING THE SHOULDER STRAP
1. Loosen and remove the bolt in the hook of the strap
(Fig. J1 & J2).
2. Attach the hook onto the shaft as Fig. J3 shown and
lock it with the bolt (Fig. J4).
D-4 Wing Nut
H-1 Soft Sleeve
H-2 Warning Label
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1510E
WARNING:
Only fix the hook of the strap between
the housing and the soft sleeve on the shaft.
OPERATION
WARNING:
Do not allow familiarity with this
product to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety
glasses with side shield, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING: To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material
from the unit.
You may use this product for the purposes listed below:
Trimming: used for removing grass and weeds up against
walls, fences, trees and borders.
Cutting: used for cutting the grass that is difficult to
reach using a normal mower.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use, for example edge trimming, is
deemed to be a case of misuse.
ATTACHING/DETACHING THE BATTERY PACK
NOTICE: For better balance, when you use BA3360/
BA4200 batteries, please cooperate it with the
backpack harness(BH1000).
Fully charge before first use.
To Attach
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a "click" (Fig. K2).
To Detach
Depress the battery-release button and pull the battery
pack out as Fig. L shown.
EN
13