Haier QNE27J Serie Manual Del Usuario página 13

INSTALLATION INSTRUCTIONS
INSTALLING THE REFRIGERATOR - FRENCH DOORS
1. REMOVING DOORS (Cont.)
D. Lift the hinge straight up to
free the hinge pin from the
socket in the top of the door
and pass the wire through the
slot in the hinge.
E. Remove the tape from the
door, open the door 90 degrees
the center hinge pin.
F. Set the door on a non-scratching surface with the
inside up.
3. REMOVING CENTER HINGES AND
BRACKETS
A. Using a 1/4" Allen wrench, remove the 2 hinge pins from
the hinge brackets.
B. Using a 5/16" socket/ratchet driver, remove the bolts
securing the center hinge brackets to the cabinet.
ENGLISH
49-60806
REINSTALLING DOORS
WARNING
Follow all steps. Failure to follow these
instructions, leaving off parts, or overtightening screws,
can lead to the door falling off and result in injury and
property damage.
When replacing french doors:
• Read the instructions all the way through before starting.
CAUTION
Lifting Hazard.
Single person lift can cause injury. Use assistance when
handling, moving or lifting the refrigerator doors.
NOTE: When moving door, to prevent damage to door
and electronics carefully place the door in a proper
location.
WARNING
To eliminate the risk of electric shock or injury during
installation, you must first unplug the refrigerator before
proceeding. Failure to follow these instructions can result
in electrical shock.
1. REINSTALLING CENTER HINGE BRACKETS
AND HINGES
A. Using a 5/16" socket/ratchet driver, reinstall the bolts
and center hinge brackets to the cabinet.
B. Using a 1/4" Allen wrench, reinstall the 2 hinge pins into
the hinge brackets.
13