Bosch PSR 10,8 LI Manual Original página 50

OBJ_BUCH-623-001.book Page 50 Tuesday, March 4, 2008 1:53 PM
50 | English
This enables screws to be screwed in, even when the bat-
tery is empty and allows for the machine to be used as a
screwdriver.
Run-on Brake
When the On/Off switch 9 is released, the chuck brakes
to a stop, thus preventing the run-on of the tool.
When driving in screws, wait until the screw is screwed in
flush with the material and then release the On/Off
switch 9. By doing so, the head of the screw does not
penetrate into the material.
Battery Charge-control Indication
The battery charge-control indicator 5 indicates the
charge condition of the battery for a few seconds when
the On/Off switch 9 is pressed half or fully through. It
consists of a three-colour illuminating LED.
LED
Continuous lighting, green
Continuous lighting, yellow
Continuous lighting, red
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be
subject to overload. When the load is too high or the al-
lowable battery temperature of 70 °C is exceeded, the
electronic control switches off the power tool until the
temperature is in the optimum temperature range again.
In case of overload, the battery charge-control indicator 5
additionally flashes three times red and the "Power
Light" 7 flashes three times white.
2 609 002 549 | (4.3.08)
Capacity
≥ 70%
30—70%
≤ 30%
Bosch Power Tools