Trouble Shooting - Grizzly Tools CH 2000 Li Traducción Del Manual De Instrucciones Original

Do not throw batteries into dome-
stic waste, fire (risk of explosion) or
water. Damaged batteries can harm
the environment and your health if
poisonous fumes or liquids escape.
• Return the unit to a recycling centre.
• Defective units returned to us will be
disposed of for free.

Trouble Shooting

Problem Possible cause
Battery (
Appliance
Battery (
won't start
Safety switch (
pressed properly
On/Off switch (
Internal loose contact
Intermittent
operation
On/Off switch (
Knife bar (
Knife bar
becomes
Knife bar (
hot
Too much friction due to lack
of lubrication
Too much friction due to miss-
ing lubrication
Knife bar (
Bad trim
Knife bar (
Bad cutting technique
9) discharged
9) not inserted
4) not
7) defective
7) defective
2) is blunt
2) is notched
2) dirty
2) blunt
• Dispose of the batteries according to
local standards. Hand in discharged
batteries at a used battery collection
point where they are recycled in an
environmentally friendly manner. For
more information, please contact your
local waste management provider or
our service centre.
• Throw the cut grass on the compost.
Do not throw it in the normal house-
hold waste.
Corrective action
Recharge battery (Observe the sepa-
rate operating instructions for the re-
chargeable battery and charger)
Insert battery (Observe the separate
operating instructions for the re-
chargeable battery and charger)
Turn on (see "Operation")
Send in to Service Centre for repair
Send in to Service Centre for repair
Have the Knife bar sharpened or
replaced (Service Centre)
Have the Knife bar checked or re-
placed (Service Centre)
Oil the knife bar (
Lubricate knife bar (
Clean knife bar
Grind or have knife bar replaced
(Service Centre)
See ("Working with the hedge trim-
mer")
GB
2)
2)
67