Trouble Shooting; Fault Correction - Grizzly Tools EHS 500-45 Traduccion Del Manual De Instrucciones Originales

GB

Trouble Shooting

Problem
Device does not
start
Device runs with
interruptions
Blades ( 8)
become hot
58
Possible cause
Mains voltage not on
On/Off switch (
defective
Worn carbon brushes
Defective motor
Power cable is damaged
Internal loose electrical
connection
On/Off switch (
defective
Blades ( 8) are blunt
Blades ( 8) are notched
Too much friction due to lack
of lubrication

Fault correction

Check plug socket, cable, line and
plug, where appropriate, have
repaired through electrical specialist
3)
Repair by Service Centre
Check the cable and have it changed
by the Service Centre if necessary
Repair by Service Centre
3)
Have the blades (
replaced (Service Centre)
Have the blades (
replaced (Service Centre)
Oil the blades (
8) sharpened or
8) checked or
8)