Configuring The Computer; Checking The Ip Address - Conceptronic C150APM Guía De Instalación Rápida

ENGLISH
The access point is configured with a fixed IP address. In order to configure the access point, your
computer needs to have an IP addres in the same IP range as the access point.
Note: The fixed IP address of the access point is: 192.168.0.2

5.1 Checking the IP address

You can check if your computer is having an IP address in the same IP range as the access point with the
'Command Prompt' of Windows. This example is based on Windows 7 and Vista with Service Pack 1.
Windows 7 and Vista need administrative rights to perform the steps below, which are explained in the
following steps.
A. Click on 'Start', 'All Programs', 'Accessories', right click on 'Command Prompt' and select 'Run as
administrator'.
You might get a warning message, which you will need to accept by clicking 'Continue' or 'Yes'.
The Command Prompt window will appear. Make sure the 'Command Prompt' title bar mentions
"Administrator: Command Prompt". When "Administrator" is not mentioned, you do not have the
necessary administrative rights for these steps and you will need to perform step A again.
B. Enter the command 'IPCONFIG' and press 'ENTER' on your keyboard.
You should see the following information:
IPv4 Address : 192.168.0.xxx (where xxx can vary between 3 ~ 254).
Subnet Mask : 255.255.255.0
26

5. Configuring the computer

B