Conceptronic C150APM Guía De Instalación Rápida página 34

ENGLISH
Note: When changing settings in the configuration of the C150APM you will always be asked to choose
between two options:
- Continue
- Apply
J. Click on the 'Apply' button to save the settings in the memory and restart the C150APM.
During the restart, the 'OK' button is grayed out and shows a countdown timer. When the restart is
complete, click 'OK' to return to the web configuration of the C150APM.
The 'bridge' mode configuration is now complete. You can now disconnect the C150APM from your
computer and connect it to the network device where you configured the bridge for.
Note: If you assigned a temporary fixed IP address to your computer in chapter 5.2, you need to set
your computer back to the original settings. You can follow the steps in chapter 5.2. At step E,
select 'Obtain an IP address automatically'.
Your Conceptronic 150
34
: Continue to make changes (the changes are not yet saved in the memory).
: Apply all changes by saving them to the memory and restart the C150APM.
is now ready to use as wireless bridge!
Wireless Access Point
N