After Using The Machine; After Use; Transport; Storage - Makita VC2000L Manual Original

with the rubber membrane through the vacuum inlet.
Make sure that the rubber membrane is passing past
the heightening at the vacuum inlet.
After emptying: close motor top to the container
and secure the motor top with the latches. Never
pick up dry material without filter fitted in the ma-
chine. The suction efficiency of the machine de-
pends on the size and quality of the filter and dust
bag. Therefore – use only Original filter and dust
bags.
4

After using the machine

4.1

After use

Remove the plug from the socket when machine is
not in use. Wind up the cord starting from the ma-
chine. The power cord can be wound up around the
motor top or at the container or placed in the includ-
ed hook, or fastening means. Some variants have
special storage places for accessories.
4.2

Transport

1. Before transporting the machine, close all the
latches.
2. Do not tilt the machine if there are liquids in the
dirt tank.
3. Do not use a crane hook to lift the machine.
4.3

Storage

CAUTION
Store the appliance in a dry place, protected
from rain and frost. The machine shall be sto-
red indoors only.
4.4

Recycling the machine

Make the old machine unusable.
1. Unplug the machine.
2. Cut the power cord.
3. Do not discard of electrical appliances with
household waste.
As specified in European Directive 2012/19/EU
on old electrical and electronic appliances,
used electrical goods must be collected sepa-
rately and recycled ecologically.
5

Maintenance

5.1

Regular servicing and inspection

Regular servicing and inspection of your machine
must be carried out by suitably qualified personnel in
accordance with relevant legislation and regulations.
*) Optional accessories / Option depending on model
In particular, electrical tests for earth continuity, in-
sulation resistance, and condition of the flexible cord
should be checked frequently.
In the event of any defect, the machine MUST be
withdrawn from service, completely checked and
repaired by an authorized service technician.
At least once a year, a Makita technician or an in-
structed person must perform a technical inspection
including filters, air tightness and control mecha-
nisms.
5.2 Maintenance
Remove the plug from the socket before performing
maintenance. Before using the machine make sure
that the frequency and voltage shown on the rating
plate correspond with the mains voltage.
The machine is designed for continuous heavy work.
Depending on the number of running hours – the
dust filter should be renewed. Keep the machine
clean with a dry cloth, and a small amount of spray
polish.
During maintenance and cleaning, handle the ma-
chine in such a manner that there is no danger for
maintenance staff or other persons.
In the maintenance area:
• Use filtered compulsory ventilation
• Wear protective clothing
• Clean the maintenance area so that no harmful
substances get into the surroundings
During maintenance and repair work all contami-
nated parts that could not be cleaned satisfactorily
must be:
• Packed in well sealed bags
• Disposed of in a manner that complies with valid
regulations for such waste removal.
For details of after sales service contact your dealer
or Makita service representative responsible for your
country. See reverse of this document.
D
Makita VC2000L
GB
F
NL
I
N
S
DK
FI
E
P
GR
SLO
HR
SK
CZ
PL
H
RO
BG
RUS
KAZ
EST
LV
LT
AL
MK
SR
UK
ZH
AR
27