Getting Started; Using The Remote Control - Lenco DVP-733 Manual De Instrucciones

Using the Remote Control

To load a battery in the remote:
1. Pull in the direction of the arrow.
2. Slide the compartment out.
3. Place the battery in the compartment with the positive side ( + ) facing up.
4. Push the compartment in to close.
• Point the remote at the remote sensor of the photo frame at a distance of no more than 15"
and at an angle no greater than 60 degrees.
• Batteries will last for about one year under typical usage.
• Replace the batteries if the remote is no longer working.
• Do not spill water on the remote control.
• Do not use the remote control for other equipment at the same time.
• Remove the batteries if the remote control will not be in use for an extended period of time.

GETTING STARTED

16
See Power Connections section.
.