Cupra CHARGER Manual De Instrucciones página 30

COLOR CODING FOR RS485 CABLE
Wires
Color
kWh meter connection
See chapter Set DIP-switches for the
DIP-switch settings required.
5. Remove cardboard cover.
6. Optionally, connect the RS485 cable.
a. Insert the three wires into the kWh meter
following the color coding above.
b. Push the cable's connector into
the dedicated port on the
communication board.
7. Optionally, install and connect
the Ethernet cable.
a. Strip the outer insulation of the cable,
then strip and crimp the individual wires
to a suitable length for the Ethernet
connector.
b. Mount the Ethernet connector.
c. Connect Ethernet cable to the
communication board.
8. Mount front cover:
a. Connect the HMI cable to the HMI board.
b. Connect the RFID cable to the HMI board.*
c. While holding the front cover next to the
main assembly, connect the HMI cable to
the power board.
d. While holding the front cover next to
the main assembly, connect the RFID
cable to the communication board.*
e. Before closing the wallbox, check and
ensure the following:
N P
White Red
37 / A 36 / B
I. All cables are connected properly.
II. The communication board is in the correct
position. Check by pressing on it gently.*
III. The charging cable holder is aligned with
the edges of the main enclosure.
IV. The rubber seal of the charging cable
and the rubber seal of the front cover
are in the correct position, clean and
not damaged.
V. There is no risk for the cables to
be trapped between main assembly
and front assembly.
f. Place the front cover onto the main
assembly by using the provided hooks
of the front cover. Mount the front cover
by tightening the six screws M4 x 10 mm.
* For CUPRA Charger Connect and CUPRA
Charger Pro only.
9. Align the bezel with the UP arrow on the
inside pointing up. Push the bezel onto
the front cover so it locks in position.
10. Wind the charging cable around the wallbox
for proper storage.
11. Turn on the input power of the station.
The wallbox state LED comes on to show
that the wallbox is starting up to become
ready to charge. See chapter Status
indication for more information.
PE
Black
35 / C
3 1