Cupra CHARGER Manual De Instrucciones página 44

A DJU ST T HE LE NGTH O F THE CHA RG ING CA BLE.
1. Loosen the two screws of the charging cable strain relief with
a Torx 10 screwdriver.
2. Hold the cable and adjust the position of the charging cable
holder by turning it counterclockwise.
3. When the desired length is reached, adjust the orientation of
the charging cable holder and tighten the two screws of the
strain relief with a torque value of 4 Nm.
1.
4. Adjust the length of the wires as required.
2.
T10
3.
T10
4 Nm
4 5