Cupra CHARGER Manual De Instrucciones página 31

SET DIP-SWITCHES.
The power board has two groups of 5-pin DIP-switches:
• Group A determines the coil type used for the current transformer and defines the
ground loss monitor functionality.
• Group B determines the maximum available current of the facility/house,
or of the wallbox itself, depending on the group A configuration.
In the following illustrations and tables, the upper switch position is being referred to
as position 1, whereas the lower switch position is being referred to as position 0.
DIP-switch positions:
Example of DIP-switch setting: 0, 0, 0, 1, 1
3 2
GROUP A
CT-TYPE
GROUP B
P LIM