YATO YT-82234 Manual Del Usuario página 13

GB
During the work you should be doing regular breaks during which you must control the status of the sheet and the degree of fi lling
of the container on the dust. If you observe, that abrasive sheet was clogged by dust in the course of work or that the grit has been
break-out, you should replace the sheet with a new one.
Additional notes
Declared, total value of vibration was measured using a standard test methods and can be used to compare one tool with another.
Declared, Declared total value of vibration can was used in a preliminary assessment of exposure.
Attention! The vibration emissions when working with the tool can diff er from the declared value, depending on how you use the tool.
Attention! You must specify the security measures to protect the operator, which are based on an assessment of exposure in the
actual conditions of use (including in it all parts of the work cycle, such as, for example, the time when the tool is turned off or
idling and the activation time).
MAINTENANCE AND OVERHAUL
ATTENTION! Before any adjustment, technical service or maintenance operations unplug the tool. Once the operations have been
fi nished, the technical conditions of the tool must be assessed by means of external evaluation and inspection of the following
elements: body and handle, conductor with a plug and defl ection, functioning of the electric switch, patency of ventilation slots,
sparking of brushes, noise level of functioning of bearings and gears, start-up and smoothness of operation. During the guarantee
period, the user cannot dismantle the electric tools or change any sub-assemblies or elements, since it will cancel any guarantee
rights. All irregularities detected at overhaul or during functioning of the tools are a signal to have the tool repaired at a service
shop. Once the functioning has been concluded, the casing, ventilation slots, switches, additional handle and protections must be
cleansed with a stream of air (at a pressure not exceeding 0.3 MPa), with a brush or a cloth without any chemical substances or
cleaning liquids. Tools and handles must be cleansed with a clean cloth.
O R I G I N A L I N S T R U C T I O N S
13