Cleaning With The Brush - Panasonic ES8249 Manual Del Usuario

Ocultar thumbs Ver también para ES8249:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
If the status lamp blinks or glows
Follow the steps outlined below if the status lamp blinks or
glows during the "Clean/Dry/Charge" course or the "Clean/Dry"
course.
Blinks
Glows
Correctly set the
Remove the shaver from the self-
detergent cartridge
cleaning recharger and then check
and then restart a
that the [CLEAN] lamp has gone
course.
out. (Be careful as the blade may
be hot or wet.) Check that the
water tank is correctly attached,
If the status lamp
the water tank cap is securely
goes out
closed and the self-cleaning
recharger is placed horizontally.
Continue a course.
When an abnormality
has been corrected
Press and hold
[SELECT] for 2
seconds to turn off the
status lamp and then
restart a course.
When the status lamp
goes out
Continue a course.
10
GB
When no abnormality was found
It is time to replace the detergent
cartridge and cleaning liquid
inside the water tank.
Wash away the old cleaning
liquid and then rise the water
tank. Restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
We recommend that you clean your
shaver with the self-cleaning recharger or
the "sonic" vibration turbo-cleaning mode
when the faucet symbol
appears on
the LCD panel.
1. Disconnect the power cord from the
shaver.
2. Apply some hand soap and some
water to the outer foil.
. Press the OFF/ON switch for more
than 2 seconds to activate the turbo
mode for "sonic" vibration cleaning.
appears on the LCD panel.
After about 20 seconds, it will be
automatically turned off, or you can
turn it off by pressing the OFF/ON
switch.
4. Remove the system outer foil.
. Press the OFF/ON switch for more
than 2 seconds to activate the turbo
mode and clean it with running water.
6. Wipe off any drops of water with a dry
cloth.
7. Remove the system outer foil to allow it
to dry completely.

Cleaning with the brush

1. Press the system outer foil release buttons and lift the
system outer foil upwards.
3
4
5

Publicidad

Tabla de contenido
loading

Tabla de contenido