Product Description; Inserting Batteries; Taking A Measurement - Braun VitalScan 3 Manual Del Usuario

Product description

A Display
B Memory button («memo»)
C Time/date button
D Start/stop button (I/O)
E Battery compartment
F Battery compartment cover
G Cuff

Inserting batteries

• Use alkaline batteries, type LR 03 (AAA) as supplied
with this product.
• Remove the battery compartment cover (F) and
insert two batteries with correct polarity (see symbol
in the battery compartment (E)).
• New batteries will provide approximately 200
measurements.
• Only discard empty batteries. They should not
be disposed of in the household waste, but at
appropriate collection sites or at your retailer.
Key rules for accurate blood pressure measurement
• Always take readings at the same time of day, ideally in the morning, under the
same conditions.
• Do not measure within 30 minutes after smoking, coffee or tea consumption.
• Take off wrist watch and jewelry before fitting the monitor on the measuring
arm.
• Wait approximately 3 minutes before repeating a measurement.
4

Taking a measurement

1. While taking a measurement, sit down, relax, keep still, especially the hand of
the measuring arm, do not move or speak.
2. Fasten the monitor on the palm side of your wrist, roughly 2 cm below the palm
line.
Make sure that the cuff (G) fits tightly.
3. Press the red I/O button (D).
1.
4. Hold the monitor at heart level.
The measurement starts automatically. While measurement is in progress, do
2x AAA (LR03)
not move or speak.
4.
5. At the end of the measurement, a beep sounds and the reading is displayed:
Upper (systolic) value
Lower (diastolic) value
Pulse
6. Press the start/stop button to turn the product off. Otherwise the product will
turn off automatically after 2 minutes.
If at any time, you want to stop the measurement, press the red I/O button.
2. 3.
2 cm
6.
5.
5