Safety Precautions - Campingaz Xcelerate 600 SV Instrucciones De Empleo

the injector are not obstructed by dust or
spider's webs.
Gas leaks
Do not check for leaks using a flame. Use a
gas leak detecting liquid.
- Apply gas leak detecting liquid to the
cylinder/relief valve/pipe/stove unions.
- The control knobs should remain as set (•).
- Open the gas supply (valve or lever on the
relief valve).
- Any gas leaks will be indicated by bubbles.
- Tighten the collars if fitted to stop the leak.
Replace any defective parts. The stove
must not be used until all leaks have been
eliminated.
- Close the valve on the gas cylinder.
Important:
An overall inspection and leaks check must
be carried out at least annually and always
after changing the gas cylinder.
E - USE

SAFETY PRECAUTIONS

It's recommended that protective gloves
be worn to handle components which
may be very hot.
Do not use the stove within 20 cm
of a wall or similar surface, or any
combustible object.
Place the stove on a horizontal surface
and never move it while it is in operation.
In the event of a leak (smell of gas), close
all valves.
Wait until the device has completely
cooled before handling or storing it.
After use, always close the valve on the
relief valve or gas cylinder.
Do not use containers of diameter
greater than 26 cm or less than 16 cm.
Do not use containers of diameter
greater than 26 cm or less than 16 cm.
Keep young children away from the
appliance, some parts can be very hot.
When lighting a burner, position the
burner adjustment knob on the maximum
flow rate position (
The appliance must not be placed on
a combustible surface (plastic, cloth,
etc.). It is recommended that is should
be placed on a surface that resists heat
(concrete, stone, brick, directly on the
ground) or that a good incombustible
thermal insulator should be positioned
between the appliance and its support.
Setting up
- Pull the lid closure hook, then open it.
- Check that the pan supports are correctly
positioned.
- Check that the gas supply pipe is not
trapped under the product and that it
is positioned so that it is not subject to
mechanical stresses (torsion, sharp parts of
furniture...)
Your appliance is ready to use.
"STOPGAz" flame safety device
The burners
thermocouple placed in the flame controlling
a valve that automatically cuts of the gas
supply to the burner when this goes out (air
current or overflow of liquids for example).
9
).
are equipped with
GB
a