CAUTION
Carefully change the spark plug, if
necessary, using one having the same
rating.
Before refitting the plug, thoroughly clean
the electrodes and the insulator using
a metal brush. Smear graphite grease
on spark plug thread, manually screw it
fully home, then tighten it to a torque of
10÷12 Nm - 1.019÷1.22 Kgm - 7.37÷8.85 ft/
lb. Loosen the spark plug then tighten
it again to 10÷12 Nm - 1.019÷1.22 Kgm -
7.37÷8.85 ft/lb.
Spark plugs with cracked insulators or
corroded electrodes should be replaced.
30
EN -
TYRE CHECK
This motorcycle is equipped with tubeless tyres.
Check the condition of the tyres, they should not
-
have any cracks, abrasions, etc.; also check the state
of wear of the tread by means of the indicators on
the tyre.
Check the tyre pressure, which should be as indicated
-
under TECHNICAL DATA.
MINIMUM HEIGHT OF THE TREAD
FRONT
3 mm (0.12 in)
REAR
3 mm (0.12 in)
WARNING
The front and rear tyre must be of the
same brand and model. Using different
types of tyre for the front and rear wheel
will compromise motorcycle stability and
handling.
Note
Tyres age even if they do not visibly appear worn;
cracks in the sides or deformation of the tyre casing
are a sign of ageing. Have the tyres checked by a
tyre dealer before using the motorcycle.
WARNING
Using the motorcycle with the tyres
inflated to an incorrect pressure or with
worn or deteriorated tyres may cause
serious injury or death if losing control of
the motorcycle.
e.g.: 3 mm
0.12 in.