Combined Instrument - SWM VAREZ 125 Manual - Uso - Mantenimiento

COMBINED INSTRUMENT

The motorcycle is equipped with a combined instrument
divided into the following zones:
1.
Signal lights (see "Warning and signal lights").
2.
Multifunction display (see "Multifunction Display").
3.
Tachometer: Indicates engine rpm.
CAUTION
Maintain the engine speed lower than
11500 rpm. If this speed is exceeded, the
engine may be damaged.
4.
"SET" key: Lets you view the various multifunction
display functions, change unit of measurement,
reset some values and set the clock (see
"Multifunction display"). Press the button to switch
from one function to another.
5.
Fuel level indicator.
WARNING AND SIGNALLING LIGHTS
1.
Left direction indicator light.
2.
Right direction indicator light.
3.
High-beam light.
4.
Neutral warning light.
5.
Engine failure warning light.
6.
Fuel reserve warning light.
7.
Engine coolant overtemperature warning light.
Turning Indicator Lights
The light flashes when activating the left- or right-
hand turning indicator using the control lever on the
left-hand switch.
High-beam light
The light comes on when activating the high-beam
light using the control on the left-hand switch.
Neutral warning light
The light comes on when the gear shift lever is in
neutral position (no gear engaged).
Engine failure warning light
When the ignition key is turned, the engine control unit
runs a self-test, the light comes on for a few seconds
and then goes off if no fault is found.
If the light comes on while the engine is running, it
means that there is an engine or injection system
failure:
stop and turn off the engine;
-
wait for a few minutes and restart the engine. If the
-
light comes on again, contact your nearest SWM
dealer to have the self-test system checked.
11
EN -